1. Refrigerator Door
Parts Requirements: The Door Is Required To Have A Straight Appearance; It Has Suitable Hardness To Ensure That It Will Not Deform After Foaming.
Material Requirements: The Appearance Is Straight; The Hardness Is Above HRB40.
Recommended Materials:
(1) Color-Coated Steel Sheet TDC51D+AZ 0.45-0.5mm.
(2) Ordinary High-Strength Steel BJD300, 0.35-0.4mm, Yield Strength ≥ 300MPa.
(3) Oil-Resistant Color-Coated Sheet TDC51D+Z, 0.4-0.5 Mm. (4) Antibacterial Color Coated Board TSECD/TDC52D+Z, 0.4-0.5mm.
(4) Antibacterial Color Coated Board TSECD/TDC52D+Z, 0.4-0.5mm.
2. Back Panel
Parts Requirements: Good Corrosion Resistance, Good Heat Resistance, Heat Dissipation And Beautiful Appearance Surface Are Required.
Material Requirements: Good Processing Properties.
Recommended Materials:
(1) Chrome-Free,AFP, Spangle Aluzinc Sheet DC51D+AZ, 0.28-0.35mm;
(2) High-Strength, Chrome-Free, AFP, Spangle Aluzinc Sheet DC51D+AZ, 0.28-0.29mm.
3. U Panel
Parts Requirements: U Panel Requires Appropriate Rigidity For Easy Handling; Straight Appearance; Appropriate Hardness To Ensure No Deformation After Foaming.
Material Requirements: The Appearance Is Straight; The Thickness Is Above 0.35mm And The Hardness Is HRB40.
Recommended Materials:
(1) Color-Coated Sheet TDC51D+AZ 0.45-0.5mm.
(2) Ordinary High-Strength Steel BJD300, 0.35-0.4mm, Yield Strength ≥ 300MPa.
(3) Oil-Resistant Color-Coated Sheet TDC51D+Z, 0.4-0.5 Mm.
(4) Antibacterial Color Coated Board TSECD/TDC52D+Z, 0.4-0.5mm.
4. Bottom Plate
Parts Requirements: The Bottom Plate Requires No Fatigue Cracking Under Vibration Conditions, And Has Suitable Strength To Meet The Bearing Requirements.
Material Requirements: Good Stamping Performance, Suitable Strength And Tensile Strength.
Recommended Material: Hot-Dip Galvanized DC51D+Z, 1-1.2mm, Used After Spraying.
5. Hinges
Parts Requirements: The Hinge Must Have Appropriate Strength And Rigidity To Ensure That It Does Not Deform After Bearing.
Material Requirements: Smooth Appearance, Yield Strength Above 200MPa.
Recommended Material:
(1) Normal Cold SPCC, 3mm, Used After Electroplating.
(2) Hot-Dip Galvanized High-Strength Steel BJG-PX, 1-1.2mm, Tensile Strength> 380MPa.
