Anodized Aluminum Product Introduction
Based on our area of expertise,we have always focused on the production of anodized aluminum coil using sulphuric acid in a continuous direct current process.Today,the coil is used wherever long-term stability and robust resistance are as important for surfaces as a decorative look.
Along with lighting and traditional decorative sector,it is now also the furniture,automobile,electronics and electrical industries that attach ever greater importance to such high-quality and non-sensitive surfaces.
Dingang offers a wide range of standard anodized surfaces.Their properties range from mat to bright reflective,recyclable,coloured,scratch-resistant,antistatic,paintable and sterilizable.This is complemented by multitude of surface structures.
Ask us for advice on the right choice of material.
Control the light - impossible with white
Keep control of the light distribution with aluminum surfaces!
The directed light is important and effective for you illumination!Reflectance 85-98%.
The reflector shape determines the light distribution!
Abrasion Resistance Test
Non Anodized Aluminum
Untreated aluminum has a relatively soft surface that is susceptible to physical damage.Through natural formation of a thin layer of aluminum oxide,it loses some of its reflective properties over time (degradation of the total reflectance and specular reflection).
Thin Layer Anodized
A relatively thin layer of aluminum oxide (200-400nm) may produce slightly higher degrees of reflectance;this type of anodized aluminum surface,however,is highly susceptible to damage.On the other hand,these material qualities are ideal for further coating using varnishing or primer systems.
Adding a sufficiently thick layer of aluminum oxide in an anodising process,the surface is protected in the long term to maintain its properties.Used in typical applications indoors and in closed systems,the oxide layer is almost as hard as glass showing marked resistance to aging and wear for a surface with long-term stability.
Lack of control due to the use of white painted (non metal) surfaces!
The reflection will be mainly diffuse!Reflectance 85-97%.
Only 4-6% of the light emitted by your light source can be controlled by the shape of the reflector!
I. Lighting: Such as grille lamp, lampshade, grille, diffuser of fluorescent lam
II. Reflector plate of solar energy
III. Exterior of construction
IV. Interior decoration, such as aluminum buckle plate, ceiling, curtain wall
VII. The face panel of household appliance, microwave oven, refrigerator, etc.
Contact Person: Mr. Robert
Tel: +86 15961206328